Precision Mro Solutions

SIZE: 2" X 6' LONG
Introduction:
Wrap Seal® ULTRA Quick Repair Kit for Active Pipe Leaksis a leak repair system that no shutdown required. It is applicable on any metal or non-metal pipes and used in
many industries such as oil and gas, petrochemical, offshore, marine, etc.
Features:
Repairs under active leak up to 150 psi (11 kg/cm²) pressure
 Applicable to pipes up to 18” (457 mm) diameter
 Withstand pressure up to 500 psi (35 kg/cm²)
 Withstand temperature up to 200 °C (392 °F)
 Safe for drinking water and resistant to most chemicals
 Ideal for pipeline reinforcement
Typical Properties:
Operating temperature                -50 °C to 200 °C (-58 °F to 392 °F)
Tensile strength                          3,920 psi (276 kg/cm²)
Bond strength                             230 psi (16 kg/cm²)
Compression strength                 13,750 ± 530 psi (967 ± 37 kg/cm²)
Yield strength                              2,260 psi (159 kg/cm²)
Cured hardness                          82 Shore D
Dielectric strength                       400 Volts/mil
Application:
Pipe repairs:
active pipe leaks
sealing joints
hazardous material spill control
reinforce thinning walls
Repairs in hard to reach areas
Underwater repairs
Directions for Use:
1. Minimize the flow rate and reduce system pressure
2. Roughen the area to be repaired
3. Knead the Seal Stic®
4. Place the Seal Stic® away from the leak location
5. Start wrapping the SealXpert® Ultra Sealing Tape a few distances away from the leak location
6. Continue to wrap SealXpert® Ultra Sealing Tape onto pipe while pushing the Seal Stic® onto leak location
7. Immerse Wrap Seal® Fiberglass Tape into water
 
8. Wrap the Wrap Seal® Fiberglass Tape above the repair tape as tightly and evenly as possible, using the entire roll
9. Discard the plastic tube at the end of the roll
10. Wet gloves in water and quickly compress the
bubbling resins back into the fiberglass wrap until all
bubbling has stopped.
11. Repair completed with smooth and hard ivory
 
appearance